Silicon Image SataRaid Manual do Utilizador Página 1

1 Serial ATA RAID PCI Card User Manual

10 BIOS Configuration The Serial ATA 2-Channel RAID adapter BIOS will appear every time your system starts up

115. When prompted, press S to specify the location of the driver. 6. Insert the floppy disk, then press Ent

12 For Windows® XP/Server 2003 For New Installation A new installation requires a floppy disk for the driver i

13 For An Existing Installation 1. Setup the RAID Array prior to driver installation and boot up to Windows.

143. Restart the computer when prompted by Windows’ installation. 4. At the Windows Setup screen, press F6 t

154. Click Finish.

16For Windows® Vista For New Installation A new installation requires a floppy disk for the driver installatio

17 For Windows® Vista-x64 For New Installation A new installation requires a floppy disk for the driver instal

18Windows. 2. At Found New Hardware Wizard, select Locate and install driver software (recommended). 3. Ple

19Management Software. 1. Please insert the CD driver bound with SATA 150 PCI RAID card into your CD-ROM Dr

2Features  Silicon Image SiI3512 SATA controller chip  Compliant with PCI Specification, Rev. 2.3  Compl

3 Hardware Installation 1. Turn Off the power to your computer and any other connected peripheral devices. 2.

44. Attach the other end of the Serial ATA cable to the Serial ATA port on the SATA 150 PCI RAID Card. 5. Fo

5the RAID BIOS. 2. At the next screen select Create RAID Set, then press Enter. 3. Select Striped, then pres

6Enter. 8. When asked Are You Sure(Y/N)?, press Y to accept. 9. Press Ctrl+E to exit the BIOS. 10. When ask

7installing a conventional hard drive. For Existing Hard Drives with Data 1. As the BIOS boots press Ctrl+S

8complete, disregard the message, continue booting, and let the Mirror rebuild. Rebuilding a Failed Mirror Se

93. Select the RAID set then press Enter. 4. When asked Are You Sure(Y/N)?, press Y to confirm. Resolving C